0c00_0100
Moderate
Bambu Lab · FDM 3D Printers
Motor X Noise Detected - X-Axis Motor Vibration Anomaly
Quick Answer
Error code 0C00_0100 on your Bambu Lab FDM 3D Printers means: Motor X Noise Detected - X-Axis Motor Vibration Anomaly. This is usually fixable — see the step-by-step guide below.
Affected Models
Likely Causes
How to Fix It
1
Run the vibration compensation calibration from the touchscreen menu
2
Check the X-axis belt tension by plucking it and listening for a low twang (should feel firm but not overly tight)
3
Clean the X-axis linear rail with a lint-free cloth and apply fresh lubricant
4
Listen to the X motor during movement to determine if the noise is mechanical (bearing) or resonance (belt)
5
Inspect the X motor pulley set screws for tightness
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Replacement X-axis belt (Gates GT2 6mm)
Linear rail lubricant (Bambu Lab recommended)
Replacement X motor (if bearing failure confirmed)
Related Error Codes