wifi_module_error
Moderate
Elegoo · Resin (SLA/MSLA) 3D Printers
WiFi Module Not Responding or Failed Initialization
Quick Answer
Error code WIFI_MODULE_ERROR on your Elegoo Resin (SLA/MSLA) 3D Printers means: WiFi Module Not Responding or Failed Initialization. This is usually fixable — see the step-by-step guide below.
Likely Causes
How to Fix It
1
Power cycle the printer and wait 60 seconds before checking WiFi connectivity
2
Verify the WiFi antenna cable is connected inside the printer (requires removing the bottom panel)
3
Re-flash the latest firmware from the Elegoo website which may include WiFi module patches
4
Try connecting to a 2.4GHz WiFi network (most Elegoo WiFi modules do not support 5GHz)
5
If the module consistently fails, it may need hardware replacement under warranty
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Replacement WiFi module (soldered to mainboard on most models, may require board replacement)
WiFi antenna cable
Related Error Codes