HomeBrandsGEOvens & Rangese2
G
e2
Moderate
GE · Ovens & Ranges
Sensor Value Out of Expected Range
Quick Answer
Error code E2 on your GE Ovens & Ranges means: Sensor Value Out of Expected Range. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
JB645RKSSJGB735SPSSJS760SPSSJT5500SFSSPGS930YPFSPT9050SFSS
Likely Causes
  1. Temperature sensor is reading a resistance value outside the normal operating range
  2. Sensor has degraded over time and drifted out of calibration
  3. Wiring has a high-resistance connection reducing the signal level
  4. Wrong replacement sensor was installed with incorrect resistance characteristics
How to Fix It
1
Disconnect power and measure the temperature sensor resistance at room temperature
2
Compare the reading to the expected value (approximately 1080 ohms at 77 degrees F for most GE RTD sensors)
3
If the value is more than 50 ohms off from the expected reading, replace the sensor
4
Check all wiring connections for tightness and clean any corroded pins
5
After replacement, run an oven calibration cycle if your model supports it
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Oven temperature sensor (part #WB21X5301)
Electrical contact cleaner
Related Error Codes
F0F1F2F3F4
Video Guides
Loading video guides…
Search more on YouTube →