e93
Moderate
Electrolux · Dryers
Configuration Error - EEPROM Mismatch
Quick Answer
Error code E93 on your Electrolux Dryers means: Configuration Error - EEPROM Mismatch. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
Likely Causes
How to Fix It
1
Disconnect power for 10 minutes to allow a full control board reset, then restore power
2
If the error persists, verify that the installed control board part number matches the correct part for your model
3
Consult the service manual for your specific model to perform a configuration reset or EEPROM reprogramming procedure
4
If a new board was recently installed, ensure it has been configured for the correct dryer model and features
5
Contact Electrolux technical support for the configuration code specific to your model if reprogramming is needed
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Main control board (part #137070860, model-specific)
Service manual with configuration codes
Related Error Codes