e07
Moderate
FlashForge · FDM 3D Printers
Z-Axis Movement Error - Motor Stall or Position Loss
Quick Answer
Error code E07 on your FlashForge FDM 3D Printers means: Z-Axis Movement Error - Motor Stall or Position Loss. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
Likely Causes
How to Fix It
1
Clean the Z lead screw with a dry cloth and apply fresh PTFE lubricant
2
Check the Z motor coupler set screws for tightness
3
Manually turn the lead screw by hand (printer off) to check for rough spots or binding
4
Inspect the anti-backlash nut for visible wear and replace if there is noticeable Z-axis play
5
For dual-Z machines, ensure both lead screws are aligned and turn freely
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
PTFE dry lubricant for lead screw
Replacement Z motor coupler
Replacement anti-backlash nut
Replacement Z stepper motor
Related Error Codes