e08
Moderate
FlashForge · FDM 3D Printers
Extruder Motor Error - Feeder Motor Stall or Fault
Quick Answer
Error code E08 on your FlashForge FDM 3D Printers means: Extruder Motor Error - Feeder Motor Stall or Fault. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
Likely Causes
How to Fix It
1
Unload the filament and inspect the nozzle for clogs by doing a cold pull at 90C with cleaning filament
2
Check the extruder drive gear for worn teeth or filament shavings packed between the teeth
3
Inspect the filament spool for tangles that may be resisting feeding
4
Verify the extruder motor cable is firmly connected
5
Replace the nozzle if it cannot be cleared by cold pulling
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Replacement nozzle (0.4mm standard, FlashForge OEM)
Replacement extruder drive gear
Cleaning filament (nylon-based)
Nozzle cleaning needles
Related Error Codes