17 known error codes for this model

BED_HEATING_FAILED Moderate

Heated Bed Cannot Reach Target Temperature Within Timeout

BED_THERMAL_RUNAWAY Moderate

Heated Bed Temperature Exceeded Safety Limits

E_DRIVER_ERROR Moderate

Extruder Stepper Motor Driver Fault Detected

E_MINTEMP Easy Fix

Extruder Thermistor Disconnected or Reading Below Minimum

FILAMENT_RUNOUT Easy Fix

Filament Sensor Triggered - No Filament Detected

HEATING_FAILED Moderate

Hotend Cannot Reach Target Temperature Within Timeout

HOMING_FAILED Moderate

Axis Cannot Find Home Position Via Endstop

KILL Easy Fix

Firmware Emergency Stop Activated

MAXTEMP Moderate

Temperature Reading Exceeds Maximum Safe Value

MINTEMP Moderate

Temperature Reading Below Minimum Threshold

POWER_LOSS Easy Fix

Power Loss Recovery Mode Triggered

SD_ERROR Easy Fix

SD Card Read Failure During Print

THERMAL_RUNAWAY Moderate

Hotend Temperature Exceeded Safety Limits

USB_DISCONNECT Moderate

Serial USB Connection to Host Computer Lost

X_DRIVER_ERROR Moderate

X-Axis Stepper Motor Driver Fault Detected

Y_DRIVER_ERROR Moderate

Y-Axis Stepper Motor Driver Fault Detected

Z_DRIVER_ERROR Moderate

Z-Axis Stepper Motor Driver Fault Detected