HomeBrandsKenmoreWashing Machinesf1e2
K
f1e2
Moderate
Kenmore · Washing Machines
Motor Control Board Error
Quick Answer
Error code F1E2 on your Kenmore Washing Machines means: Motor Control Board Error. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
203622130222352261322713241262
Likely Causes
  1. Motor control unit (MCU) has an internal component failure
  2. Communication between the main control board and the MCU is disrupted
  3. Drive motor is drawing excessive current, damaging the MCU power stage
  4. Wiring harness between the MCU and the main board or motor is damaged
How to Fix It
1
Disconnect power for 5 minutes and restore to attempt a reset
2
Access the motor control unit, typically located near the drive motor at the bottom of the washer
3
Inspect the MCU for burn marks or damaged power components (MOSFETs, capacitors)
4
Check the wiring harness connections between the MCU, main board, and drive motor
5
Replace the motor control unit; if the new MCU also fails, test the drive motor for a short circuit
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Motor control unit/MCU (model-specific)
Drive motor (if shorted, causing MCU damage)
Wire harness repair kit
Related Error Codes
F0E1F0E2F0E5F1E1F2E1
Video Guides
Loading video guides…
Search more on YouTube →