i60
Moderate
Frigidaire · Dishwashers
Heating Issue - Water Not Heating to Target Temperature
Quick Answer
Error code i60 on your Frigidaire Dishwashers means: Heating Issue - Water Not Heating to Target Temperature. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
Likely Causes
How to Fix It
1
Disconnect power and access the heating element from underneath the dishwasher or inside the tub base
2
Test the heating element for continuity with a multimeter (should read 10-30 ohms depending on wattage)
3
Check the thermal fuse (if equipped) for continuity; replace if it is open
4
Test the NTC temperature sensor resistance (approximately 50k ohms at room temperature)
5
If the heater and sensor test good, the control board heater relay may be faulty
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Heating element (model-specific)
Thermal fuse
NTC temperature sensor
Control board (if relay is faulty)
Related Error Codes