e23
Moderate
Electrolux · Washing Machines
Drain Relay Failure on Control Board
Quick Answer
Error code E23 on your Electrolux Washing Machines means: Drain Relay Failure on Control Board. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
Likely Causes
How to Fix It
1
Disconnect power to the washer and remove the top panel to access the main control board
2
Visually inspect the control board for signs of burn marks, discolored relay, or bulging components near the drain circuit
3
Check the wiring harness between the control board drain relay connector and the drain pump for continuity
4
If the wiring is intact, the relay on the control board is likely failed and the board should be replaced
5
After replacement, run a drain-only test cycle to confirm proper drain pump operation
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Electrolux main control board (part #137275308)
Wire harness repair connectors
Drain pump assembly (if pump was the root cause of relay failure)
Related Error Codes