HomeBrandsElectroluxWashing Machinese35
E
e35
Moderate
Electrolux · Washing Machines
Water Overfill Condition
Quick Answer
Error code E35 on your Electrolux Washing Machines means: Water Overfill Condition. This is usually fixable — see the step-by-step guide below.
Affected Models
Applies to all models
EFLS627UTTEFLW427UIWELFW7537AWELFW7637ATELTW7637AT
Likely Causes
  1. Water inlet valve is stuck in the open position due to debris or mechanical failure
  2. Pressure switch hose is disconnected, kinked, or cracked causing incorrect water level readings
  3. Pressure switch (analog pressure transducer) has failed and is not signaling the correct water level
  4. Control board is continuously energizing the inlet valve due to a faulty output circuit
How to Fix It
1
Immediately turn off the water supply faucets behind the washer
2
Disconnect power and remove the top panel to locate the pressure switch and its small rubber hose running down to the tub
3
Inspect the pressure switch hose for kinks, cracks, or disconnection at either end; blow gently through the hose to verify it is clear
4
Test the water inlet valve by disconnecting power to it; if water still enters the tub, the valve is stuck open and must be replaced
5
If the valve and hose are fine, replace the pressure switch (analog pressure transducer)
Pro Tip
This fix requires some technical knowledge. If you're unsure about any step, consider contacting support or a qualified technician.
Parts You May Need
Electrolux pressure switch/transducer (part #137015400)
Pressure switch hose
Water inlet valve (part #137353500)
Related Error Codes
E11E13E21E23E38
Video Guides
Loading video guides…
Search more on YouTube →